Page 6
INSPECTION
1) Frequency:
1) Before each use inspect according to steps listed in this manual. Remove
equipment from field service if it has been subjected to damage or has been
subjected to a fall arrest force.
2) Annually: This equipment must be inspected according to steps listed in this
manual by a competent person, other than the user, at least annually.
2) Inspection Steps:
1) Inspect rebar chain assembly hardware (snap hooks, carabiners, quick-
links, etc.) for damage, distortion, sharp edges, worn parts, or corrosion. The
snap hooks or carabiners must work properly. Hook gates must move freely
and lock upon closing. Inspect chain for damage, distortion, sharp edges,
worn links, or corrosion.
3) Labels must be present and fully legible.
4) Inspect each system component and subsystem according to manufac-
turer’s instructions.
5) Record inspection date and results on the inspection log on the product
label.
3)
If inspection reveals an unsafe or defective condition, remove rebar chain
assembly from service and destroy.
MAINTENANCE, SERVICING, STORAGE
1) Clean the rebar chain assembly with water and mild detergent. Wipe off
hardware with a clean, dry cloth and hang to air dry. Do not force dry with heat.
An excessive build-up of dirt, paint, etc., may prevent the rebar chain assembly
from working properly. If you have questions about the condition of your rebar
chain assembly, contact Reliance.
2) Additional maintenance and servicing procedures must be completed by
Reliance or parties authorized in writing. Do not disassemble this equipment.
3) Store the rebar chain assembly in a cool, dry, clean environment, out of
direct sunlight. Avoid areas where chemical vapors are present. Thoroughly
inspect this equipment after extended storage.
SPECIFICATIONS
Rebar Hook:
Alloy Steel or Alloy Aluminum
Connector Hook:
Alloy Steel
Chain:
Twisted 5.0 Alloy Machine Chain
Minimum Strength:
5,000lbs (22kN)
This product complies with all applicable OSHA Standards and ANSI A10.32– 2004
