Decorative Bollard Installation
Adhesive Anchoring
1-877-789-3245 | [email protected] | www.reliance-foundry.com
4"
4"
PARTS LIST
DESCRIPTION
PART
NUMBER
QTY
ITEM
R7530 Base
R7530B
1
1
Drop-in
Concrete
Insert 3/4" -
requires 1" x
3 1/8" hole
(dia. x depth)
Drop-in
Concret
e Insert
3/4"
1
2
R7500
Threaded
Bar 3/4" x
30"
R7500B
AR 3/4"
1
4
R7530 Cap
R7530C
1
7
Hexagon
Socket Set
Screw 3/8" x
3/4" -
requires
3/16" hex key
Hexago
n
Socket
Set
Screw
3/8" x
3/4"
1
8
Polyethylene
Plug 3/8"
Polyethy
lene
Plug
3/8"
1
9
Install Plastic
Screw Cap
A
STEP 8
STEP 12
STEP 13
STEP 11
STEP 14
STEP 15
R-7530
Inspect the installation
. Abrasions should be
covered as soon as possible. For damage repair
or other servicing needs, please contact Reliance
Foundry’s sales department.
Secure the Bollard
STEP 7:
Clear the hole of all debris and/or standing water
using the vacuum. Use a brush to remove any remaining
loose particles.
STEP 8:
Using the caulking gun, dispense the adhesive from
the bottom up until the hole is one-quarter full. Prevent air
pockets by withdrawing the mixing nozzle slowly.
STEP 9:
Carefully place the bollard near the installation
position. When ready to install, remove its protective
packaging.
STEP 10:
Set the bollard base upright and maneuver it so
the center lines up with the drilled hole.
STEP 11:
Lower the threaded rod through the top of the
bollard and into the drilled hole.
STEP 12:
Insert the threaded rod the full 4
"
into the drilled
hole while turning for positive adhesion. The rod should
be centered in the bollard’s shaft.
Note: A minimum of 45
minutes at 68˚F is required for the anchoring system to set.
STEP 13:
Place the washer over the threaded rod so it
rests on top of the bollard base. Apply the 1" nut to the
threaded rod and use a wrench to tighten until the bollard
is secure.
STEP 14:
Remove the bollard cap from packaging and place
on top of the shaft of the bollard. Secure and align the
bollard cap to the bollard base with the three set screws.
Tighten in equal amounts to ensure the cap remains
centered.
STEP 15:
Place the plastic plugs
(A)
over the heads of the
set screws.
