Reliable 2200SZ, Инструкция по эксплуатации

Страница: 6 / 28

1.Place bobbin on bobbin winder spindle (3), Fig. 7,
pushing it on as far as it will go.
Pre-tension (1) (see Fig.7).
+ ..... More tension .
.. ... Less tension.
2.Push latch (2) in the direction indicated by arrow (A),
then start the machine (see Fig.7).
Bobbin winder spindle (3), rotate in the direction
indicated by arrow (B) (see Fig.7).
To adjust the amount of thread on bobbin, loosen
screw (4) on latch (2) and swing the latch (2) away from
you or toward you, as required.
For more thread on bobbin, swing latch (2) away from
you.
For less thread on bobbin, swing latch (2) toward you.
If thread winds unevenly on bobbin, loosen screw (5)
and move pre-tension (1) up or down, as required, and
tighten screw (5).
10.THREADING THE BOBBIN CASE.
�/
Fig.8.
Fig.9. Fig.10
. 5.
Fig.11.
.Hold bobbin case so that thread unwinds ln the
direction shown in Fig.8, and put bobbin in bobbin
case.
2.Pull thread into notch (1 ), and draw it under tension
spring (2) (see Fig.9).
3.Draw thread out from slot(2) on end of spring (1 ),
(Fig. 1 O) and pass it through bobbin case thread guide
(1),Fig.11. Allow about 4 inches of thread to hang
freely from bobbin.
NOTE: When straight stitching, a better result can be
obtained if bobbin thread is not threaded
through bobbin case thread guide (1),Fig.11.
11.TO REPLACE THE BOBBIN CASE.
3
4
2
Frg.12.
A
&
CAUTION
Switch off the machine.
Do not run machine without closing
bed slide. Danger of injury!
Hold bobbin case by latch ( 1) and place it on spindle of
bobbin case holder (2) so that position finger (3) enters
notch (4) at right of bobbin case holder (see Fig.12).
Release latch and press bobbin case firmly in place to
assure proper position. Close bed slide.