Reliable Equipment REL-CS16, Руководство оператора

Страница: 8 / 24

8
HOSES AND FITTINGS
There exists the potential for shock in using anything other
than certified nonconductive hoses and hydraulic oil with
dielectric properties, when using system components near
energized electrical lines. Failure to recognize these conditions
could cause electrocution.
Hoses and fittings used with this tool must comply with S.A.E. J1273 which covers
recommended practice for selection, installation, and maintenance of hose and hose
assemblies. The
correct hoses and fittings are available from your supplier.
WARNING: Failure to comply with these warnings could result in severe bodily injury.
WARNING
UNIT/HOSE CONNECTIONS
ALWAYS SHUT OFF pump/power source before connecting or
disconnecting system components. ALWAYS DEPRESSURIZE
hydraulic system before disconnecting this unit or any of the
systems components.
ALWAYS TIGHTEN couplings completely. Loose or improperly
tightened couplings will not allow fluid to pass through the hose
creating a blockage in the supply or return line.
WARNING
HOSE INSTALLATION
Care must be taken to assure the correct connection of the hoses
to the pressure “P” and return “T” ports. If the hoses are incor-
rectly connected, the tool will run in reverse. This will damage
the tool and create dangerous conditions for the operator.
Always inspect hoses and connectors before using this tool
each time before using. Replace or repair if any leakage is
evident. Leakage is a sign of deterioration in component parts.
Worn or leaking parts must be repaired or replaced, or injury
and severe damage could result.
C A U T I O N