21
22
A thermal overload device is fitted to all SerieT/i Sub-Bass Systems. If the unit is deliberately overdriven this
device will sense the temperature rise and cut the output; recovery time is approximately five minutes. If
this happens, it is a warning that the unit is being overdriven and the volume level control should be reduced
to a safe level.
Although everything possible has been done to minimize risk of thermal overload failure, there can be no
defense against those individuals who deliberately abuse the device. Such damage is NOT covered by warranty.
Please remember your REL is there to supplement your main system, not overwhelm it!
Power Saving Efficiency
All REL sub bass system designs utilize a true On-Off switch that affords the owner the ability to turn off
their unit completely, without having to unplug the A/C mains cord. When a REL sub bass system is switched
off using the On-Off switch on the rear panel it draws ZERO power.
It is not necessary to switch your SerieT/i off between listening sessions- it will not significantly shorten its
life by leaving it switched on. On the other hand, it will not harm sound quality if it is always switched off.
It is perfectly safe to leave your SerieT/i on under all normal domestic circumstances as it is fully protected
by internal fuses and an external mains fuse in the mains input socket. There is a spare fuse inside the
input socket.
T/9i Specifications
Type:
Passive Radiator, front-firing active woofer, down-firing passive radiator
Active Drive Unit:
10in., 254 mm long-throw, inverted dust cap, steel chassis
Passive Radiator:
10in., 254 mm
Lower Frequency Response:
28 Hz at -6 dB in room
Input Connectors:
Hi Level Neutrik Speakon, Lo Level single phono, LFE phono
Input Impedance:
High Level: 150kΩ, Low Level: 10kΩ, .1/LFE: 10kΩ
Gain Control Range:
80 dB
Power Output:
300 Watts (RMS)
Phase Switch:
Yes, 0 or 180 degrees
Amplifier Type:
Class AB
Wireless Capability:
Yes - REL Arrow™ wireless system [required], Sold separately
Protection System
Fully Electronic SET-SAFE:
Yes
D.C. Fault:
Yes
Output Short:
Yes
Mains Input Voltage:
220-240 volts, 110-120 volts for certain markets
Fuses:
3.15 Amp semi delay 230 volts operation
6.3 Amp semi delay 115 volts operation
Dimensions (WHD):
Including Feet and Rear Panel Controls
13 x 15.2 x 16 in., (330 x 387 x 407 mm)
Add 1.75 in (44.5 mm) in depth when using Hi Level connector
Net Weight:
41.3 lbs. (18.7 kg)
Finish:
Gloss Piano Black or White Lacquer
Supplied Accessories
Mains Lead:
Yes
Neutrik Speakon Interconnect:
Yes (10 Meters Nominal)
Users Manual:
Yes
Содержание T/i Series
Страница 1: ......
Страница 15: ...25 26 Notes...
