Pg. 46
Doc ID: 191-7913A
Doc Rev: 082018
If you disassemble the EXP, the Teflon pads may fall out
or be stuck to the ramp surfaces of the EXP bases. Take
care to ensure all pads are correctly placed into wedge
pockets using gentle pressure to avoid damage to the
pad surfaces before reassembling the EXP. Properly
seated pads will be secured in place once the EXP is
reassembled. Operating the clutch without the pads in
place will cause part damage or failure.
BUMP-STARTING
If your bike needs to be bump-started due to a dead battery
or any other reason, follow the steps below to quickly bump-
start your bike.
1. Turn the adjustable slave cylinder counterclockwise to
collapse the gap until no resistance is felt.
2. Bump start the bike. The clutch will function like a manual
clutch at this point, but the clutch will not be fully over-
ridable at high RPMs.
3. Once the bike is started, readjust the installed gap.
