Reka 20710, Руководство пользователя

Страница: 16 / 20

14
After Sales Support
UK/N.IRELAND HELPLINE N O :
REP.IRELAND HELPLINE N O :
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
enquiries@quesh.co.uk
Alternate Installation
If you don’t have a double stud you will need to make a mounting
board using marine ply or suitable material. Use the supplied wall
plugs and coach screws to hang the board. To fix the bracket to the
plate you will need to use 4 x M6 nut and bolts with 8x washers.
Use a stud finder to find the distance between the outer edges of
the studs. This will tell you the length of board you will need. The
height of the board should be 260mm. Use a twist drill bit to drill
the holes to mount the board to the studs, loosely secure in to
place as you will need to remove it after the next step.
Once the board is fitted, place the bracket in to position and mark
the holes the same as page 5. Remove the board from the wall and
drill the placement holes for the bracket. You will need to
counter sink the rear holes to accommodate the washer diameter
and the depth of the bolt head. Put the bracket into place lining
up the holes. Put a washer on the M6 bolt and pass it through the
holes from the back. Place another washer on the end of the bolt
and tighten the nut. Once all four bolts have been fitted, place the
completed mount on the wall and secure it tightly with the coach
screws.
Bracket
Placement Mounting
Board
Stud Stud