Reiner P1-MP, Руководство по эксплуатации

Страница: 4 / 9

9
1. Making the print head ready for use
1.1. Opening the pack _ Fig.
A
The aluminium pouch has a resealable zip fastening
2
.
„
With scissors, cut open the top of the pack between
the weld seam
1
and the zip fastening
2
.
„
Unzip
2
the pack.
„
Take out the print head
4
.
1.2. Releasing the clip _ Fig.
B
+
C
The print head
4
is supplied with a reusable clip
3
.
„
Place the print head
4
on a firm surface at an angle
of about 45° as shown in figure C .
„
Hold the red clip
3
by the point with one hand.
„
With the other hand, press the print head
4
down firmly. The
clip arms
5
will spring out and the print head
4
will slide
away from the clip
3
.
2. Printing material
For the best results, use material that is clean, non-greasy, dry
and at the same temperature as the print head.
Before carrying out a large print job, perform a test print.