Reiner jetStamp 790, Краткие инструкции, Страница: 22 / 88

21
jetStamp 790/790 MP
jetStamp
792/792 MP
1. Preparation and Taking into Operation
1.1. Commissioning
jetStamp
790/790 MP
Only connect the device to the PC after the 790 PCset easy software has been installed.
The batteries must be completely charged before using the stamp for the first time.
This takes about 14 hours.
Inserting rechargeable batteries

Fig. B
f
Open the battery compartment
2
on the back of the stamp.
f
Check for correct polarity and insert the batteries.
f
Close the battery compartment
2
.
Charge batteries

Fig.
A
+
D
f
Put the jetStamp 790 in the charging station
4
with the locking tab
8
first.
f
Connect the Mini-USB socket
7
of the charging station
4
with the mains unit with the
USB cable.
f
Connect mains unit to the mains.
f
Batteries are charged when the green charging control light
6
is lit.
f
Charging condition is displayed by the symbol in the display
12
after a few minutes.
Troubleshooting
The following message appears in the display
12
after inserting batteries
“EMPTY BATTERY - NO IMPRINT POSSIBLE“.
The batteries have not been recognised by the system.

Press any key.
The display
12
is dark or lines appear.
Unallowed inputs may have been made.

Press the reset button
3
.
1.2. Commissioning
jetStamp
792/792 MP
Only connect the device to the PC after the 790 PCset easy software has been installed.
f
Connect jetStamp 792 to the connection electric stamp of the adapter.
f
Connect mains unit to the connection voltage supply of the adapter.
f
Push mains unit into the socket.
The display
12
shows “INPUT - TIME 1”.