REI VPC 2.0, Руководство пользователя

Страница: 15 / 20

OPERATION
14
2) Remove the 2 small Phillips head screws that secure the battery door to the monitor enclosure.
3) Remove the old CR2032 battery from the battery clip and replace with a new CR2032 battery;
the positive (+) side should be facing up, away from the circuit board.
4) Replace the battery door and secure with the Phillips head screws.
Note: The provided internal coin cell is a CR2032 battery with the following specifications: 3V nominal
voltage, 225 mAh nominal capacity, -30

C to 60

C operating temperature.
Assembling the Unit
Follow these simple steps to begin using the Pole Camera:
1. Remove the main body of the Video Pole Camera, which includes the pole and monitor, from
the case.
2. Remove the camera from the case.
3. Position the camera head connector to the pole connector so that the “V” shaped key on the
inside of the camera head connector aligns with the keyway of the connector on the pole. Slide
the camera head onto the pole until the camera head will not push on any more.
4. Tighten the knurled ring from the pole connector onto the threads from the camera head
connector. DO NOT TWIST THE CAMERA HEAD. Doing so will permanently damage the
connector.
5. Place one of the provided rechargeable batteries in the battery compartment.
“V” key
Keyway
Knurled ring