4
OPERATION
1)
Power On/Off Button
Press the Power Button to turn the unit ON or OFF. The button will illuminate RED
when OFF and BLUE when ON.
Note: Radio can also be powered on by pressing any front button.
2)
Volume/Select Knob
Rotate the knob left or right to change the volume level.
Press the knob to select one of the following functions:
VOL---BASS---TREB---BAL--FAD
Upon choosing the function, rotate the knob to adjust the desired setting.
PLEASE NOTE: If the Volume/Select Knob has not been adjusted for 5 seconds it will
automatically revert back to volume function.
3)
Auto Store / Preset Scan Button
Press and hold this button for 2 seconds to auto program available stations into the
preset memory buttons. This function will erase previous memorized stations and store
the newly searched stations. Once completed, the radio will scan for 5 seconds through
each of the preset stations of either the AM or FM band and stop.
Press this button momentarily to scan preset stations.
4)
Preset Memory/Recall Buttons
Press one of these buttons momentarily to select preset station.
Press and holding a button will preset the current station to the button being pressed.
**Preset buttons are pre-assigned frequencies in Weather Band Mode.
5)
BAND Select Button
Press this button to change radio bands as follows:
FM1—FM2—FM3—AM1—AM2 —WB1
6)
TUNE / SEEK Buttons
Under Radio mode, press the desired button momentarily to manually tune a station
moving upward or downward. Press and hold a button and the radio will automatically
seek the next available radio station. These buttons also function as Weather Band
Channel 7 (162.550 MHz) access. Under weather band mode, pressing these buttons
will select weather band channels 1-7.
7)
DISP Button
Press this button to change between Clock and Mode Information display.
Setting the Time:
With the radio’s power ON, press this button momentarily to display the time. Next,
press and hold this button until the hour display begins to flash. Rotate Volume/Select
Knob to adjust the hour. Press the DISP button again, and the minute display will flash.
Rotate VOL/SEL Knob to adjust the minute. Press the VOL/SEL button to save the
time on the LCD.
9
2.
Pass the harness and antenna cable through the DIN collar, and connect to the
back of the radio. Verify clearance; then gently insert the radio into the DIN Collar
until both spring clips are locked into place.
3.
If additional support is needed, bend the included support bracket, and secure it
to the vehicle using a screw. Secure the opposite end to the radio’s rear stud using the
nut provided.
REAR
STUD
BRACKET
SUPPORT
SCREW
HEX
SPLIT
WASHER
NUT (M5)
