5
5.
How to connect and operate the receiver
“POWER”: The POWER button can be used to turn the
receiver on or off; note that a press and hold is needed
to turn the receiver off.
“MODE”: Press to alternate between manual and auto
frequency selection. Auto mode is selected
when “SCAN”
is displayed on lower middle section of display:
In this mode; pressing the up or down arrows will
automatically scan and select an open
Channel/frequency. In manual mode; the frequency and
channel can be manually selected by the user with the
up or down arrows.
“ACT”: Auto-Channel-Targeting. Can be used to pair the
wireless transmitter to the previously selected frequency.
Press the ACT button; the display will flash ACT. and the
IR LED will begin to blink indicating that the receiver is
ready to send a signal. Turning on and pointing the
transmitter toward the receiver will automatically
establish a connection and pair the two devices.
“UP˄” “DOWN˅”: Press either button to adjust upwards
or downwards. Press and hold to auto-adjust upwards or
downwards.
Adjusting the Volume: Toggle the
“MODE” button to get
to volume set
ting, use “UP” and “DOWN” arrows to
adjust the volume accordingly.
To Lock Unit: Press and Hold the
“MODE” button;
display will flash either Lock or Un-locked, repeat to
obtain preferred setting.
6.
UHF wireless microphone
Insert 2 x AA 1.5V rechargeable batteries inside battery
compartment.
MAKE SURE THE BATTERY POLARITY
IS CORRECT.
