REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER ENERGY 8
SERVICE MANUAL
FOOTPLATE DISTANCE
The particular characteristic of this MODEL is the 7° front frame taper.
As it is visible from the picture, the longer the footplate distance
DP
, the
narrower the room
X
between the two frames at footplate’s level.
According to that, when adjusting the footplate distance, it is necessary to
keep the 7° taper and increase or decrease the room
X
.
After adjustment, the forks have to be perpendicular to the ground. That will
tell you keep the 7° frame taper.
All footplates available for this model allows for such adjustment.
HEIGHT ADJUSTMENT EVERY 1.5cm
Usually, it is granted an adjustment of +1.5 cm and - 1.5 cm with respect to
the footplate distance requested.
Remove the bolts
A
and their corresponding nuts and washers
B
.
Slide the footplate tube up or down until the necessary height.
Insert the bolts through the nearest holes and tighten.
After adjustment, check that between the lower side of the footplate and the
ground there is at least 2 cm and that there is no interference between foot-
plate and casters.
Rubber adaptor for round footplate tube on elliptical tube (from 2019).
The round footplate tube needs the adaptor
C
to fit the elliptical frame tube.
The adaptor’s hole is not centred, therefore, you have to pay attention to
mounting right and let adaptors in the same way.
The adaptor
C
is usually mounted with its narrower side facing frontward. In
order to avoid squeezing the adaptor too much, do not tighten the bolt very
hard.
The hard plastic adaptor, used for titanium tubes (diameter 18 instead of
20), works in the same manner.
With elliptical footplate tubes, the adaptor is not present.
X1
X2
X3
DP
7°
7°
90°
B
A
C
Hard plastic adaptor for
titanium tubes
