2. EXTENSION:
The extension angle is adjusted using the upper slider
(2).
To change the extension angle, press the round
button in the central part of the slider and move it to
the appropriate extension value. After setting the but-
ton in a right place, release it. The button will pop out
and lock the slider against the accidental movement
by the user.
The splint is equipped with the following angles of
joint extension:
full mobility, 30°, 10°, 0°, -10°.
OPEN>10°
(2)
3. CONSTANT JOINT LOCK:
It is possible to permanently lock in the required angle
of the joint, what is very useful when it is necessary
to immobilize a limb. The angle is locked in a given
setting using a slider
(3)
in the upper part of the splint.
To set the angle of the joint lock, press the round button
in the central part of the slider and, holding it, flex the
splint in the axis of its rotation. When the appropriate
angle value is opposite the slider, move it clockwise
and release the round button. The slider will lock
automatically when the round button will pop up
and the metal part slides into the appropriate value.
The splint can be locked in the following angles:
full mobility,
90°, 80°, 70°, 60°, 50°, 40°, 30°, 20°,
10°, 0°, -10°.
The skin is protected with special soft cushions, so
using the splint is comfortable.
>40°<
ATTENTION:
If the brace is equipped with two side splints, the adjustment should always be made
separately on each of the splints, setting the range of motion at the same angle of flexion,
extension or lock.
(3)
(3)
© Reh4Mat 2020
