(A)
(B)
3
( )
( )
( )
( )
( )
1
2
ATTENTION:
Before setting up the splint, remove the screws from it.
1. Place the brace in the position in which you want to adjust the flexion (extension).
2. Place the screw in the hole setting appropriate angle and check the if it works correctly.
3.
(A) - The holes indicated in the picture as (A) are responsible for flexion.
(B) - The holes indicated in the picture as (B) are responsible for extension.
ATTENTION:
If the brace is equipped with 2 side splints, adjustment is done on each side
splint separately setting the same angle of flexion and extension. Side splints do not require
maintenance.
REH4MAT
Ul. Piaski 47, 36-060 Głogów Małopolski | Poland
tel. +48 16 62 142 20 e-mail: [email protected] www.probraces.com www.reh4mat.com
Fax +48 16 62 21 42 13
HOW TO SET UP THE FLEXION
AND EXTENSION IN
1RP SPLINT - INSTRUCTION
This brace is equipped with the following ROM adjustment: flexion 30°, 50°, 70° and extension: 0°, 20°.
THE ANGLE OF FLEXION AND EXTENSION IS SPECIFIED BY THE DOCTOR
OR PHYSIOTHERAPIST!
© Reh4Mat 2021
