4
CTC EcoPart 400
General information
Important to remember!
Check the following points in particular at the time of delivery and
installation:
• The CTC EcoPart must be transported and stored in an upright
position. For transport into a house it may be laid on its back for
a short time.
• Remove the packaging and check before installation that the product
has not been damaged in transit. Report any transport damage to the
carrier.
• Place the product on a
fi
rm surface, preferably made of concrete.
Should the product be standing on a soft carpet, a rigid board must
be placed under the adjustable feet.
• Remember to leave a service area of at least 1 m in front of the
product. The product must not be placed below
fl
oor level either.
• Avoid placing the product in rooms with thin walls, as people in the
adjoining room may be disturbed by the compressor and vibrations.
• Ensure that pipes used between the heat pump and the heating
system are of adequate dimensions.
• Ensure that the circulation pump has suf
fi
cient capacity.
Safety Instructions
The following safety instructions must be observed when handling,
installing and using the heat pump:
• Turn off the safety (power) switch before doing any work on the
product.
• Prior
to
fi
lling the system with the recommended antifreeze
fl
uid, the
system should be
fl
ushed thoroughly with antifreeze
fl
uid.
• When handling the product with a hoist ring or similar device, make
sure that the lifting equipment, eyebolts etc. are not damaged. Never
stand under the hoisted product.
• Never jeopardize safety by removing bolted covers, hoods or similar.
• Never jeopardize safety by deactivating safety equipment.
• Any work done on the product’s electric or cooling system should be
done by a competent engineer.
• This product is intended exclusively for indoor installation.
!
Failure to follow the instructions in this Manual may void the Warranty.
