www.regentlight.co.za
www.regentlight.co.za
7
8
This product should be installed by a competent person i.e. Qualified electrician.
This product requires a constant stable electrical supply 220V - 240V VAC 50Hz - alternating current.
The product must be regularly maintained, including the replacement of lamps/LED timeously.
This product could be HAZARDOUS if not used correctly, it could cause electric shock, serious bodily harm or death.
This product is not a toy, please keep away from children.
This product may contain small parts that can be swallowed.
Use only the correct light bulbs/LED as stipulated on the carton for the product.
Any modifications of this product after supply will result in the guarantee being void.
Spare parts may become unavailable over time.Items can vary slightly from the picture on the carton
Coastal humidity can affect the longevity of the light fitting over time.
Be sure to follow the steps in the order given.
Read instructions carefully.
Important Safety Instructions
2
3
Drain Conduit
Drain Conduit locator
Casting
polystyrene
plug
Protrude the
drain conduit
through the
polystyrene
3. Place the casting polystyrene
plug with the drain conduit in position on the
slab before casting the concrete. Ensure the
polystyrene plug is at the correct level on the
positioning wedges.
Cast the concrete / surface bed.
2. Place the Drain conduit locator under the
casting polystyrene plug before placing it in
the cavity. Protrude the drain conduit
through the polystyrene.
2
3
92MM
Casting
polystyrene
plug
F.F.L
SLAB
Surface bed/
concrete
Positioning
wedge
Drain conduit
STEP 2
2
5
Polystyrene Casting plug
Surface
bed
Conduit for wiring
to main supply
4. Ensure there is a conduit in the cavity to
the main supply. All fittings are supplied with
an electrical tail.
4
5.
A.
Once the concrete has set, remove the
polystyrene casting plug from the cavity,
indicated in
A & B
.
Surface bed
without polystyrene
casting plug
Drainage
B
Casting
polystyrene
plug
Concrete
surface
bed
A
Endcap
Fisher plate
for continuous lengths
2
6
7
6. Prepare the aluminium extrusion by
fastening the end caps and/or fischer plate
(for continuous lengths) to the extrusion.
Ensure the extrusion has drainage holes.
Ensure the end caps and fisher plates are
securely fastened.
Aluminium
extrusion
FFL
TRIM
CONDUIT
TRIM
CONDUIT
7. Align and place the assembled aluminium
extrusion into the cast cavity over the drainage
conduit, ensure the extrusion protrudes from the
surface bed to the FFL.
Ensure the Aluminium extrusion is securely placed in
the cavity. Trim the protruding conduit to the base
of the extrusion.
2
8
Tiling plug
A
Tiling finished floor
Grout
Tiling plug
B
Tiling plug
C
A: I
nsert tiling polystyrene plug
into the extrusion before
grouting and tiling up to the
finished floor level.
B:
Grout around the extrusion
and tile up to the aluminium
extrusion edge or FFL.
Ensure that no grouting gets
trapped into the aluminium
extrusion.
C:
Remove the tiling
polystyrene plug from the
aluminium extrusion.
Ensure there is no grout in the
extrusion.
STEP 9 continued on the next
page...
