Regency PG33-LPG, Владельцы и установка

Страница: 26 / 44

26
Regency PG33 Gas Inbuilt
INSTALLATION
OPTIONAL BRICK
PANELS
1) Undo the bottom 2 door latches and open and
remove glass door. Remove logs.
2)
Attach the 2 Rear Brick Retaining clips to the
rear wall. Loosen the screws in the top and
rear wall of the firebox and slide the retaining
clips into position (tight against the firebox top)
and then tighten the screws.
Note: The logs must not be in the unit.
3) Insert the back brick panel by carefully slipping
it between the back wall of the firebox and the
rear log bracket.
5) Slide the Top Brick Panel into position and slide
the Top Brick Retaining clips so that they hold
the Top Brick Panel in place and tighten down
the screws.
LOG SET INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken do not
use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
Log Kit # 431-930 contains the following pieces:
A) 250 Rear Log 902-250
B) 254 Middle Cross Log 902-254
C) 253 Front Left Cross Log 902-253
D) 251 Rear Left Log 902-251
Notch
Bracket
Bracket
250
254
Vermiculite
Vermiculite
Vermiculite
250
254
The 3-digit numbers (i.e. 250) are
molded into the rear of each log.
E) 252 Front Right Cross Log
902-252
F) Embers
902-156
G) Vermiculite
902-179/21
H) Rockwool
902-153
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care -
do not force into position.
2) Sprinkle the vermiculite and embers around
the firebox base.
3) Place the Log 250 on the rear log support
pins with the flat side to the back.
4) Place Log 254 on the front right side of the
burner. Push the back of the log against the
2 brackets with the notch on the bottom right
side of the log fitting into the right side of
the grate.
5) Position Log 253 across the cutouts in Logs
250 and 254 with the notch on the left side
of the log fitting into the 2nd grate tab.
Cutouts
2nd Grate Tab
253
250
254
D) 251 A) 250
C) 253
B) 254 E) 252
4)
Put the side panels in next. Slide them in from
the front and push them flat up against the
wall. Be very careful not to scratch them on
the firebox hardware.