34
Regency
®
P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace
INSTALLATION
Option 1:
REMOTE CONTROL
Can be used with Option 2 or 3 but
not both.
Use the Regency
®
Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting plate.
1)
Choose a convenient location on the wall to
install the receiver and the receptacle box
(protection from extreme heat is very important).
Run wires from the fi replace to that location.
Use the Thermostat Wire Table.
2)
Connect the two wires to the gas valve. See
diagram below.
Option 2:
WALL SWITCH
Can be used with Option 1 or 3
but not both.
1)
Run the supplied 15' of wire through the back
gas inlet opening. Be careful not to damage
wire.
Note: We recommend a maximum of 15' of
wire but if you wish to go with a longer
run, use the Thermostat Wire Table.
2)
Connect the wire to the supplied wall switch
and install into the receptacle box.
Thermostat Wire Table
Option 3:
WALL THERMOSTAT
Can be used with Option 1 or 2 but
not both.
A wall thermostat may be installed if desired, connect
the wires as per the wiring diagram. Use the table
below to determine the maximum wire length.
Note: Preferable if the thermostat is installed
on an interior wall.
Regency
®
offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
3)
Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Install the receiver and its cover in the wall.
Switch the remote receiver to "remote" mode.
The remote control is now ready for operation.
CAUTION
Do not connect millivolt all
switch wire to a 120V wire.
CAUTION
Do not connect millivolt
wall thermostat wires
to a 120V wire.
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size
Max. Length
14 GA.
50 Ft.
16 GA.
32 Ft.
18 GA.
20 Ft.
20 GA.
12 Ft.
22 GA.
9 Ft.
CAUTION
Do not connect millivolt
remote control wires to a
120V wire.
