15
Regency I31-3 Gas Fireplace Inbuilt
INSTALLATION
Thermostat Wire Table
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 240 V wires.
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
OPTIONAL REMOTE
CONTROL
Use the Optional Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
plate.
1)
Choose a convenient location on the wall to
install the receiver and the receptacle box
(protection from extreme heat is very impor-
tant). Run wires from the fireplace to that
location. Use Thermostat Wire Table.
2)
Connect the two wires to the gas valve.
3)
Install a 9V alkaline battery in both receiver
and the transmitter. Install the receiver and
cover in the wall. The remote control is now
ready for operation.
Wire Size
Max. Length
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
15.24 m
9.75 m
6.10 m
3.66 m
2.71 m
WIRING
CAUTION:
Label all wires prior to
disconnection when
servicing controls.
Wiring errors can cause
improper and dangerous
operation.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against
shock hazard and should be plugged directly
into a properly grounded three-prong recepta-
cle. Do not cut or remove the grounding prong
from this plug.
No electrical power supply is required for the
gas control to operate. However, a 240V A.C.
power supply is needed for the fan/blower
operation.
Caution: Ensure that the wires do not
touch any hot surfaces and are away
from sharp edges.
OPTIONAL WALL
THERMOSTAT
A wall thermostat may be installed if desired.
Use chart below to determine thermostat wire
length.
Note: Preferable if the thermostat is in-
stalled on an interior wall.
Use a CSA, UCL or UL approved millivolt thermo-
stat, 250-750 millivolt rated. A non-anticipator
type thermostat must be used.
CAUTION
Do not connect the millivolt
remote control wires to
the 240V wires.
