Regency Fireplace Products E18E-LP11, Инструкция для владельца и по установке

Страница: 62 / 104

62 |
Regency
®
E18E-11 Gas Fireplace Insert
installation
Optional
WALL SWITCH
1. Run up to 10' of wire through the right or
left side gas inlet opening. Be careful not
to damage wire.
Note: We recommend a maximum of 10'
of wire but if you wish to go with a
longer run, use the Thermostat Wire
Table.
See Wiring Diagram for
Wall Switch installation
Optional
WALL THERMOSTAT
A wall thermostat may be installed if desired,
connect the wires as per the wiring diagram.
Use table below to determine the maximum
wire length.
Note: Preferable if the thermostat is
installed on an interior wall.
Regency
®
offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
CAUTION
Do not wire millivolt
wall thermostat wires
to 120V wire.
Thermostat Wire Table
Optional
REMOTE CONTROL
Use the Regency
®
Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter and receiver.
See Wiring Diagram for
Remote installation
Receiver cannot be wall mounted, receiver to be
installed in the fireplace.
1 Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Switch the remote receiver to "remote" mode.
The remote control is now ready for operation.
2. Receiver to be mounted in the fireplace--can
not be wall mounted.
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
14 GA. 50 Ft.
16 GA. 32 Ft.
18 GA. 20 Ft.
20 GA. 12 Ft.
22 GA. 9 Ft.
CAUTION
Do not wire millivolt
remote control wires
to 120V wire.
CAUTION
Do not wire millivolt
wall switch wire
to 120V wire.
f i r e - p a r t s . c o m