Assem blin g and In stalling Your Gate
**Note: IMPORTAN T y o u w il l n o t ic e a s l i g h t Ga p be t w e e n th e g a t e d o o r l a tc h a n d
the fr ame tube . THI S I S NOT A D E F E CT . Yo ur g a t e i s a p re s s ure m o un t e d g a t e a n d
this gap wi ll dis ap p e a r o n c e y o u t i gh te n y o u r g a te i n t h e do o r w a y.
Begin by locating the 4 Threaded Spindle Rods. Before you begin, turn the Adjustment Wheels
clockwise until they are almost against the flat end of the Threaded Spindle Rods. WARNING: The
Adjustment Wheel should NOT touch the flat end of the Thread Spindle Rod. If it does it might get
stuck.
You are going to insert the 4 Threaded Spindle Rods into the holes in the 4 ends of the gate frame as
shown in Diagram B1. **IMPORTANT: THE ENDS OF THE GATE FRAME ARE NOT
THREADED. THE THREADED SPINDLE RODS SHOULD SLIDE INTO THE END OF THE
FRAME TUBES WITHOUT ANY RESISTENCE. Push the Threaded Spindle Rods all the way into
the frame tube until the Adjustment Wheel hits the end of the frame tube as shown in Diagram B2.
Step 1.
Step 2.
Diagram A.
(3)
Important: Keep these
instructions for future
reference
Gate Instructions
Diagram B 1
Adjustment
Wheel
End of the
Frame Tube
Diagram B 2
