15
Table 4: Custom Schedule
Setup #2
Step 1
Step 2
Step 3
Duration
Speed
6.4 Running VGreen 165 from Keypad
1. Press the START key and the VGreen 165 will run the programmed
24 hour duration schedule. The START event will be stored in the
controller. Should a power outage occur, the VGreen 165 will
automatically re-start at STEP 1 when power is restored.
2. The VGreen 165 will always run the PRIMING sequence when it
starts from the OFF state, including when it automatically restarts
following a power outage. The default Prime setting is defined in the
“Priming” section of this document.
3. The VGreen 165 then starts running in STEP 1 at the programmed
DURATION and SPEED. The “ACTIVE LED” for STEP 1 will turn
ON. The DURATION and SPEED setting LEDs along with the re-
spective bar graph LED will blink back and forth every three (3)
seconds.
If power is connected to the VGreen 165 motor, pressing any of the following buttons
referred to in this section 6.4 could result in the motor starting. Failure to recognize this
could result in personal injury or damage to equipment.
10019878-001-001 _V-Green165 UM_7-30-19.indd 17
8/5/2019 4:26:59 PM
