Regal 29 OBX, Руководство пользователя

Страница: 168 / 324

Equipment Operation
o p q r
BILGE PUMP
Before each outing, check the operation of the bilge pump, automatic
switch, and manual switch. The bilge pump should automatically
activate when water reaches a pre-determined height in the engine
compartment. Test the bilge pup manually at the dashboard with the
switch. Periodically check for bilge debris around the grates of both
the bilge pump and automatic switch, and also bilge pump impeller.
The automatic mode for your bilge pump works similarly to the
manual method. Both methods control the bilge pump by a switch,
but the automatic mode utilizes a fl oat switch. Float switches have
a fl oat that sits at water level, and when the fl oat reaches a certain
height, it trips the switch and activates the bilge pump.
Periodically you may need to disassemble the bilge pump from the
grate in order to clean or access the inner mechanisms. To remove
the bilge pump, utilize the quick disconnect tabs on either side of the
bilge pump, squeezing them like a backpack clip while pulling up on
the pump.
For switch control location, refer to the engine and controls chapter.
For bilge and drainage system information and electrical system
information, refer to the systems chapter. Refer to the vessel
operations chapter for pre-departure use.
Typical Bilge Pump And Automatic Switch Diagram