Specifications
The all new TT PSU and motor anti-vibration circuit is a combination of the
innovative P9 power supply along with an improved P25 anti-vibration
motor drive feeding the P9 24V AC synchronous motor. The TT PSU uses
a remote "wall wart" transformer therefore keeping the sources of hum &
noise well away from sensitive parts such as the cartridge and phono
leads.
The compact TT PSU uses exactly the same high stability crystal locked
low distortion sine wave generator as is used in the heart of the P9 power
supply. This, along with an efficient drive amplifier fed from stabilised DC
power supply, generates a 24Volt AC balanced signal of less than 0.05%
distortion, which is completely un-affected by any changes in the
mains/line voltage and conditions. This then drives the turntables
anti-vibration circuit, which is situated beneath the turntable.
The drive voltage for the motor is run along the power lead to the turntable
motor, which also carries the 33/45-RPM DC relay control voltage used to
activate the anti-vibration circuit.
TT PSU MANUAL.qxd 03/08/2004 14:43 Page 7
