Installation
Servitec 35-120 with Touch controller — 06.07.2016 - Rev. B
English — 35
6.5.3
RS-485 interface
Use the S2 RS-485 interface to retrieve all controller data and to enable the communication with control centres or other devices.
– S2 interface
•
"PIS" pressure.
•
Operating modes of the "PU" pump.
•
Values of the "FQIRA +" contact water meter.
•
All messages, see chapter 9.5 "Messages" on page 64 .
•
All entries in the fault memory.
The following accessories are available for interface communication.
– Bus modules
•
Lonworks Digital.
•
Lonworks.
•
Profibus-DP.
•
Ethernet.
•
Optional I/O module, see chapter 4.6 "Optional equipment and accessories" on page 17 .
•
Modbus RTU.
Note!
If required, please contact the Reflex Customer Service for the protocol of the RS-485 interface, details of the connections
and information about the accessories offered, see chapter 12.1 "Reflex Customer Service" on page 74 .
6.6
Installation and commissioning certificate
Data shown on the nameplate:
P
0
Type:
P
SV
Serial number:
This device has been installed and commissioned in accordance to the instructions provided in the Operating Manual. The settings in the
controller match the local conditions.
Note!
When any factory-set values of the device are changed, you must enter this information in the Maintenance certificate,
see chapter 10.4 "Maintenance certificate " on page 71 .
For the installation
Place, date
Company
Signature
For the commissioning
Place, date
Company
Signature
