Notes on the operating manual
Fillcontrol Auto Make-up and degassing — 06.07.2016 - Rev. B
English — 5
1
Notes on the operating manual
This operating manual is an important aid for ensuring the safe and reliable functioning of the device.
The operating manual will help you to:
•
avoid any risks to personnel.
•
become acquainted with the device.
•
achieve optimal functioning.
•
identify and rectify faults in good time.
•
avoid any faults due to improper operation.
•
cut down on repair costs and reduce the number of downtimes.
•
improve the reliability and increase the service life of the device.
•
avoid causing harm to the environment.
Reflex Winkelmann GmbH accepts no liability for any damage resulting from failure to observe the information in this operating manual.
In addition to the requirements set out in this operating manual, national statutory regulations and provisions in the country of
installation must also be complied with (concerning accident prevention, environment protection, safe and professional work practices,
etc.).
This operating manual describes the device with basic equipment and interfaces for optional equipment with additional functions. For
optional equipment and accessories, see chapter 4.6 "Optional equipment and accessories" on page 15 .
Note!
Every person installing this equipment or performing any other work at the equipment is required to carefully read this
manual prior to commencing work and to comply with its instructions. The manual is to be provided to the device operator
and must be stored near the device for access at any time.
2
Liability and guarantee
The device has been built according to the state of the art and recognised safety rules. Nevertheless, its use can pose a risk to life and
limb of personnel or third persons as well as cause damage to the system or other property.
It is not permitted to make any modifications at the device, such as to the hydraulic system or the circuitry.
The manufacturer shall not be liable nor shall any warranty be honoured if the cause of any claim results from one or more of the
following causes:
•
Improper use of the device.
•
Unprofessional commissioning, operation, service, maintenance, repair or installation of the device.
•
Failure to observe the safety information in this operating manual.
•
Operation of the device with defective or improperly installed safety/protective equipment.
•
Failure to perform maintenance and inspection work according to schedule.
•
Use of unapproved spare parts or accessories.
Prerequisite for any warranty claims is the professional installation and commissioning of the device.
Note!
Arrange for Reflex Customer Service to carry out commissioning and annual maintenance, see chapter 12.1 "Reflex
Customer Service" on page 53 .
