Reflex Exdirt D 100, Руководство по эксплуатации

Страница: 23 / 222

Technical data
Reflex ex separator — 27.01.2014 English — 9
3.4 Installation and assembly
3.5 Notes
The following items must be considered when assembling and installing the equipment:
•
The flow direction is not pre-determined.
• Ensure a vertical and stress-free installation.
– Any stresses that may occur in some cases must be countered by appropriate constructive actions. Stresses may be caused by
temperature effects, for example.
• Ensure sufficient bearing capability of the installation site.
– This applies to filling the separator with water in particular.
• The equipment is not a load-bearing construction element.
– By default, the calculation of the vessels does not take lateral acceleration forces into account. Avoid alternating stresses such
as pressure shocks, abrupt pressure changes, or strong vibrations.
• Use only approved transport and lifting gear.
– The eyes provided on the device are intended solely as
installation aids.
• The angle (1) of the lifting tackles must be maximum 60°.
3.6 Space requirements
A: Minimum free space above the top part of the ventilation
Type:
82511 xx
82513 xx Type:
82531 xx
82532 xx
82533 xx
82534 xx
50 mm 50 mm
B: Minimum free space below the draw-off tap
Connection
Connection Type:
82531 xx
82532 xx
82533 xx
82534 xx Type:
82521 xx
82522 xx
82523 xx
82524 xx
DN 50 / 65 OD 60.3 / 76.1 400 mm 300 mm
DN 80 / 100 OD 88.9 / 114.3 550 mm 400 mm
DN 125 / 150 OD 139.7 / 168.3 750 mm 500 mm
DN 200 OD 219.1 1000 mm 700 mm
DN 250 OD 273.0 1350 mm 850 mm
DN 300 OD 323.9 1700 mm 1000 mm
60°
1
A A
B B