avoid injury.
6. When using dehumidifiers in wooden furniture , floors and other
environments in attention control humidity , excessive dry conditions may cause the
wood to crack.
7. Severe turbulence , impact and tilt angles are large damage the machine : If
running noise becomes larger and so on . And the inclination angle of the large
residual moisture may cause the machine overflow.
8. Storage H, dehumidifier
When you are not using the product for a long time , and intended to be stored or
collection, consider the following steps:
1) The residual water tank emptying.
2) The dust filter clean .
3) Placement. fresh dry environment .
※
Troubleshooting
※
Solution
Trouble
cause
Machine Won’t Work/
Display is Blank
Display Blank. Power outage
or poor connection
Check Power Supply
Check both ends of powercord
for good connection
Place unit on flat surface
in vertical orientation
Room temperature whether in
5℃~ 35℃this inner?
machinery not exceed
water or dehumidify
quantity small
Clear the filter
Filtration net whether jam
Room inner humidity temperature
too low
Normal work condition
Trouble code HI
:
Trouble code L0
:
Unit is sensing room temperature
below 33F.
Water Full protection
Repositioning or pour water tank
Reinstall the float
Outlet or the outlet is blocked
Clear obstructions
Trouble code:E1
Humidity Sensor or
communication error
Check sensor cable is properly
connected.Replace the Senser
Trouble code E4
:
Water Full protection
Unit is sensing room temperature
above 100F.
Decrease Room Temp
Check Sensor
Check Sensor Cable
Increase room temperature
Check Sensor
Check Sensor Cable
The water tank float tank drained
or re- install the float switch
normal contact
-9
-
-1
0
-
※
※
Warranty
Seller warrants the equipment to be free from defects in workmanship and materials for a
period of 12 months after shipment (60 months/5 years on compressor, evaporator and
condenser). This warranty is limited, however, to the repair or replacement of defective
equipment. If it is necessary to return unit for service, customer is solely responsible for
proper packaging, transportation costs. Customer must initiate warranty process by
contacting factory. Do not send any component or product back to factory without Return
Material Authorization.
This limited warranty does not apply to any part or component that is damaged in transit
or when handling, has been subject to misuse, corr osion, chemicals, acts of God has not been
installed, operated or serviced according to the Seller’s instructions, or has been operated
beyond the factory-rated capacity or has been altered in any way. Routine maintenance is not
covered by this warranty.
Seller’s liability is limited to replacement of defective parts or components and does not
include any cost of labor (including, but not limited to, labor to remove and/or reinstall any
defective part), refrigerant or piping. Customer may elect to have unit fixed locally in which
case required replacement parts will be sent to customer at customer’s expense.
Refine shall not be responsible for loss of use of any product, loss of time, inconvenience,
or damage to other equipment, or any other indirect or consequential damage with respect to
property whether as a result of breach of warranty, neglect, or otherwise.
REFINE-DEHUMIDIFIERS
REFINE-DEHUMIDIFIERS
