Reely 208000, Руководство по эксплуатации

Страница: 43 / 144

43
• If you do not have sufficient knowledge yet of how to fly remote-controlled helicopters, please contact an experi-
enced model sportsman or a model construction club. Alternatively, it is recommended that you practice on a suit-
able flight simulator before first use.
• Do not leave any packaging material unattended. It may become a dangerous playing material for children!
• The product has been designed for operation in an ambient temperature of between 10°C und 40°C and under
normal air humidity conditions in Central Europe in dry weather. Operation under different conditions can lead to
changed (material) properties and damage to the product as a result.
• The maximum permissible take-off weight of 1,000g must not be exceeded. A take-off weight in excess of this could
lead to damage to the rotors during operation and may cause a crash!
• Should questions arise that are not answered by this operating manual, contact us (for contact information, see
chapter 1) or another expert.
b) Before Operation
• Make sure that no other models are operated within the range of the remote control on the same remote control
channel (transmitter frequency). Otherwise, you will lose control of the remote-controlled models! Always use diffe-
rent channels if you wish to operate two or several models in direct proximity of each other simultaneously.
• Unroll the aerial wire of the receiver of the model to its complete length. Install the aerial in a way that the aerial wire
cannot be caught in any rotating parts. The antenna wire should be inserted into the antenna pipe and the loosely
coiled excess length fixed with transparent adhesive tape to the antenna pipes. Do not cut the antenna wire off
under any circumstances as this will reduce the range of the remote control.
• Regularly check the functional safety of your model and of the remote control system. Watch out for visible damage
such as defective plug connections or damaged cables.
• All moving parts of the model must run smoothly but should not have any play in their bearings.
• Check before each operation the correct and secure position of the rotors.
• Charge the flight battery, which is necessary for operation, as well as the rechargeable battery that may be inserted
in the remote control according the manufacturer’s instructions.
• If batteries are used as a transmitter power supply, make sure that they have sufficient remaining capacity (battery
checker). If the batteries are empty, always replace the complete set, never individual cells only.
• To operate your model, always pull out the telescopic aerial to its full length, because otherwise the transmitter has
a considerably lower range and the transmitter output is subject to more stress than usual.
• Always switch on the transmitter first. Please ensure that when you turn on the transmitter the throttle control is set
to the lowest setting (motors off)! Then the flight battery of the model may be connected. Otherwise, unexpected
reactions of the model may occur and the rotors might run unintentionally!
• When the rotors are running, make sure that neither objects nor body parts are in the rotating and suction area of the
rotors.