Series RS7000 / RSTW7000 Hose Reels
Page 2
www.reelcraft.com
INSTALLATION INSTRUCTIONS
MOUNTING
Caution:
Unless reel was specified differently when ordering,
maximum installation height is 16 feet. Do not exceed this dis-
tance.
1. Unpack and inspect reel for damage. Turn by hand to check
for smooth operation. Check for completeness.
2. Configure reel for top, side or bottom-wind hose dispensing
by removing nuts (1) securing guide arm bracket (2). Position
guide arm bracket to desired location, and replace nuts.
Caution:
When changing guide arm positions, the U-bolt
must be placed in the proper location as instructed in figure A
below. The reel can “latch out” during use if this instruction is
not adhered to.
3. Position reel on floor, wall, or ceiling. Secure into place using
four (customer supplied) bolts (3).
FOR NON-WELDING HOSE REELS
(RS Models Only)
INSTALLING THE INPUT HOSE
Warning:
Ensure that supply line pressure does not exceed
maximum working pressure rating of reel. Apply pipe thread
sealant to all threads.
Caution:
Use flexible hose connection at
input. Do not use rigid plumbing.
1. Connect supply line hose (4) to main shaft input (5) as indi-
cated in illustration.
INSTALLING THE OUTPUT HOSE (No Hose Model)
Warning:
Use extreme caution; reel under tension. Avoid releas-
ing latch mechanism. Apply pipe thread sealant to all threads.
1. Manually turn sheave (10) until spring is tight, back off 3
turns, then latch.
2. Route output hose (11) through guide arm bracket (2), U-bolts
(12), then through cutout (13) in spool as indicated in illustra-
tion.
3. Connect output hose (11) to swivel (14) as indicated in illus-
tration.
4. Tighten U-bolts (12).
5. Charge inlet and outlet hoses. Momentarily open control valve
on working end to purge hoses of gases. When fluid appears
at control valve, close valve. With hoses fully charged, release
latch and wind output hose onto reel.
6. Install REELSAFE
TM
hose identification sticker onto working
end of hose in a highly visible location. (Figure B)
FOR WELDING HOSE REELS
(RSTW Models Only)
INSTALLING THE INPUT HOSES
Caution:
Apply thread sealant to all input connections to insure
a proper seal.
INSTALLING THE OUTPUT HOSES (No Hose Model)
Caution:
Use extreme caution; reel under tension, avoid releas-
ing latch mechanism. Apply thread sealant to outlet connections.
1. Manually turn spool assembly until spring is tight, back off
three turns, then latch.
2. Route output hoses through guide bracket.
3. Using a wrench, firmly hold on to output fittings on swivel
while tightening the hose connector.
4. Install REELSAFE
TM
hose identification sticker onto work-
ing end of the gas hose only in a highly visible location.
(Figure B)
11
15
2
13
4
12
2
10
14
1
5
3
Figure A
Acetylene/fuel gas
inlet 1/4” FPT
(Red)
Oxygen
inlet 1/4” FPT
(Green)
Figure B
Step 1
Step 2
Step 3