Reef Pure RO Systems 4 Stage 100GPD Premium, Руководство пользователя

Страница: 5 / 11

REEF PURE RO SYSTEMS
RO/DI SYSTEM USER MANUAL
Reef Pure RO Systems
©
2019
Page of 5 11
CONNECTING AND DISCONNECT QUICK CONNECT FITTINGS
Quick connect fi ttings can be found throughout the RO/DI system and can be connected and
disconnected by following the below instructions. We recommend familiarising yourself with them
before moving on.
REVERSE OSMOSIS MEMBRANE INSTALLATION
1. Begin by disconnecting the 1/4” tube from the connector attached to the membrane housing
cap or pressure gauge, depending on your model. Note: Premium systems feature two RO
membranes, one with a pressure gauge, and one with a quick-connect
fi tting.
2. Unscrew the cap from the membrane housing and insert the membrane fi rmly into the housing
ensuring that the end with the 2 rubber o-rings is inserted fi rst. Twisting the membrane slightly
while inserting can assist the connector to seat properly in the housing. Once fully inserted, no
part of the membrane will protrude from the membrane housing.
3. Once the membrane has been fi rmly seated, seal the membrane housing by replacing the cap
and tightening.
4. Reconnect the RO tube(s) ensuring they are connected back to their original connectors. Note:
Typically tubes that were connected to pressure gauges can be easily identi fi ed by the distinct
groove left by the connector. If unsure refer the the fl ow diagrams on pages 9 and 10.
FILTER INSTALLATION INSTRUCTIONS
It is critical that the membrane is pushed in fi rmly and as far as it can possibly go. Not
doing so could allow high TDS water to bypass the membrane and make its way into
your product water, exhausting your DI resin prematurely.
!
Remove the tube by holding the round retention
ring tightly against the
fi tting then pulling the
tubing away from the fi tting while twisting. The
tubing should slowly release from the fi tting.
Push Connect fi ttings are connected by fi rmly
pushing one end of the tube into the fi tting. It is
important to push the tube all the way into the
fi tting for a complete seal.
Disconnecting Tube From Quick Connect Fittings: Connecting Tube To Quick Connect Fittings:
The frequency at which you will need to replace your RO Membrane(s) will vary based
on the the quality of your home’s tap water and how much water you have
produced/
fi ltered with the system. We recommend changing your RO Membrane
every 18 months to 2 years as a general rule.
#