MAINTENANCE
Sand and lime deposits may increase the wear of the shaft & bearings considerably and
may lead to the exclusion of warranty.
To maintain efficient performance of the pump, periodic
cleaning is required.
Thoroughly clean the pump, the drive assembly and the cooling duct
in regular intervals, at least once every six months. In case of high lime content, a lot of
sediment or failures, shorter intervals may be necessary.
WARNING:
Always unplug or disconnect the pump from the electrical supply before servicing the
pump, while the equipment is being installed or when being handled. When inserting or removing the
pump from the water, always disconnect main electrical plug.
Never yank the cord to pull the plug
from outlet.
Grasp the plug and pull to disconnect. Always unplug an appliance from an outlet when
not in use.
Never lift the pump by the cord.
SERVICING / DISASSEMBLY
1) Unplug pump from power source and detach pump from skimmer body.
2) Clean outside of pump motor body to remove any accumulated debris or buildup.
3) Inspect and clean air intake device (venturi)
4) Remove volute by unscrewing the 4 Phillips head screws holding it to the pump body.
5) Remove and inspect impeller, cooling duct and bearings for noticeable signs or wear, damage,
debris or buildup
* Be sure to handle the impeller shaft with care.
6) Soak pump body and parts in a solution of vinegar and water (50%-50% mix) for a duration
or several hours or more depending on the buildup.
DO NOT USE DETERGENTS OR OTHER
CHEMICALS CLEANERS
which could damage the pump or pollute the aquarium.
7) Rinse and reassemble the components with care.
(You can apply silicone-based lubricant to
extend the life of o-rings or gaskets before re-installing.)
8) Install pump back to skimmer body and plug into power source.
•
To keep the pump in good working order, always replace any worn parts
•
The pump motor has no user serviceable parts. If the motor or the electrical cord is damaged,
discard the pump.
•
If you have any doubts, contact your Bubble Blaster retailer or contact CoralVue.
Pump assembly diagram
Pump components
Pinwheel
Air intake Device
(Venturi)
Pump body
Volute
Screws
O-ring
