background image

http://www.reefglass.com 

[email protected] 

Page 4 of 4 

Skimmer Maintenance 
 

 

In most cases, the skimmer should be cleaned every 2–4 weeks.  Use a soft toothbrush to clean the glass skimmer body, 

rubber stopper and limewood airstone. 

 

Use a toothpick or similar object to clean any accumulated gunk that may be clogging the drain elbow. 

 

If cleaning the limewood airstone with the toothbrush does not bring it back to its normal performance, you may use a razor 
blade to remove a thin layer of dirt and wood.  Eventually, the limewood airstone should be replaced with a new one.  The 

airstone should last 2-4 months, depending on your specific conditions. 

 

If your skimmer suddenly stops generating bubbles, foam does not raise as usual or starts generating blurping sounds, make 

sure  that  the  drain  elbow  is  not  clogged,  inspect  the  drain  flexible  tubing  for  any  obstructions  and  make  sure  it  is  not 
submerged in skimmate.  Make sure that air can exit the drain tubing freely. 

 
 

Thank you very much for your purchase.  We hope you enjoy Reef Glass! 
 
 

 

Содержание Nano Skimmer

Страница 1: ...your convenience 7 O Ring Holds the glass skimmer on the acrylic mount and can be adjusted to change the positioning of the skimmer 8 Air Valve Must be inserted into the air inlet hole on the top of the rubber stopper Use it to adjust air flow to the limewood airstone 9 Drain Elbow connector One end must be inserted into the waste drain hole on the rubber stopper Connect a length of flexible tubin...

Страница 2: ...in the air inlet hole on the top of the rubber stopper It should look as shown in Figure 2 Figure 2 Rubber Stopper with air valve and drain elbow 3 Glass Skimmer Body Installation Slide the skimmer body through the O ring and into the mount from the top The O ring holds the skimmer body in place allowing you to adjust its height We recommend that you begin placing the skimmer approximately 3 5 fro...

Страница 3: ...g the instructions below 6 Tuning Your Skimmer It will take some trial and error to get your skimmer producing skimmate the way you like it Please be patient After you get it right your skimmer should operate with a high level of consistency requiring little to no adjustment other than periodic maintenance The skimmer is tuned by adjusting its height using the O ring and air volume using the air v...

Страница 4: ...s normal performance you may use a razor blade to remove a thin layer of dirt and wood Eventually the limewood airstone should be replaced with a new one The airstone should last 2 4 months depending on your specific conditions If your skimmer suddenly stops generating bubbles foam does not raise as usual or starts generating blurping sounds make sure that the drain elbow is not clogged inspect th...

Отзывы: