REED ST-8835, Инструкция по эксплуатации, Страница: 8 / 14

reedinstruments
www
com
8
Pantone 485 & 123
485 = (0/100/100/10)
123 = (0/18/100/0)
To.lock.the.unit.on.for.continuous.measurement,.slide.the.middle.switch.
LOCK ON/OFF .to.the.right..If.the.trigger.is.pulled.while.the.unit.is.locked.
on,.the.laser.and.backlight.will.be.turned.on.if.they.have.been.activated..
When.the.unit.is.locked.on,.the.backlight.and.laser.will.remain.on.unless.it.
is.turned.off.using.the.
Laser/Backlight
.button.on.the.keypad.
To.activate.the.alarms,.please.slide.the.bottom.switch. SET ALARM ..
to.the.right.
To.set.values.for.the.High.Alarm.(
HAL
),.Low.Alarm.(
LAL
).and.Emissivity.
(
EMS
), firstly activate the display by pulling the trigger or pressing the
MODE .button,.then.press.the. MODE .button.until.the.appropriate.code.
appears.in.the.lower.left.corner.of.the.display,.press.the. UP .and. DOWN .
buttons.to.adjust.the.desired.values.
Measurement Operation
1).Hold.the.meter.by.its.handle.grip.and.point.it.toward.the.surface..
to.be.measured.
2).Pull.and.hold.the.trigger.to.turn.the.meter.on.and.begin.testing...
The.display.will.light.if.the.battery.is.good..Replace.the.battery..
if.the.display.does.not.light.
3).While.measuring,.the.SCAN.display.icon.will.appear.in.the.upper.left.
corner.of.the.LCD.
4).Release.the.trigger.and.the.HOLD.icon.will.appear.on.the.LCD..
indicating.that.the.reading.is.being.held.
5).The.meter.will.automatically.power.off.approximately.7.seconds.after.
the.trigger.is.released..Unless.the.unit.is.locked.on.
How to obtain Emissivity?
In.the.EMS.mode,.press.and.hold.the.Laser/Backlight.button.until..
the.“EMS”.icon.on.the.left.side.of.LCD.blinking..At.this.time,.“.
3
=.--”..
will.appear.at.the.upper.side.of.the.LCD;.IR.temperature.value.will.be.in.
the.middle.of.LCD;.and.Type.K.temperature.value.is.at.the.lower.side.of.
the.LCD..