REED SOVA7, Руководство по эксплуатации и обслуживанию

Страница: 54 / 197

SOVA SERIES 7
PNEUMATIC SPRAYING MACHINE
SOVA
MAINT
PAGE 14
THE FEED BOWL
The top surface is originally ground with a slight concave dish radiating from the center to the
outside edge, measuring 0.002 inches (0.05 mm) to 0.005 inches (0.13 mm). The bottom surface
of the feed bowl must be maintained free of any disfiguration. This bottom surface is used to
locate the part in the grinder when it becomes necessary to resurface the top face. If there are
severe knicks on the bottom surface of the feed bowl that cannot be removed evenly with a file,
then we recommend lightly filing the top surface free of burrs and knicks and place the top
surface down in the grinder and Blanchard grind the bottom surface first. Then turn the feed bowl
over and dish the top surface.
THE RUBBER SEALING PADS
The best method of reconditioning rubber pads is also done on a Blanched grinder. Some
REED
owners report that they get an acceptable reconditioning job by freezing the pad and refacing the
frozen rubber on motorized wood plane. Others report they do acceptable refacing with an
extremely sharp knife blade that is kept well lubricated with oil during the trimming of the high
ridges of rubber.
REED pads with imbedded bosses must be resurfaced by grinding. Mill or grind
the bosses down 1/16 inches (1.5 mm) after removing the rubber required to make the face flat
and smooth. The rubber face of the pad must be kept parallel to the steel back side of the pad.
REVISION: