reedinstruments
www
com
4
Specifications
Wire Verification Distance
10,000 feet (3000 meters)
Minimum Wire Size
26 gage
Power Supply
9V battery
Product Certifications
CE
Visual Indicator
Yes (Green and Red LEDs)
Audible Indicator
Yes (Pulsating Beeper, approx. 85 dB)
Fuse Protection
0.5A/250V
Continuity Confirmation
Equal to or less than 2.0 K Ohms
Operating Temperature
14 to 113°F (-10 to 45°C)
Operating Humidity
0-85%
Storage Temperature
14 to 122°F (-10 to 50°C)
Dimensions
4.5 x 3 x 1.1 “ (115 x 75 x 29mm)
Weight
3.9oz (111g)
Operating Instructions
Remote Continuity Test
Remote continuity testing requires both the Main Unit and Remote Unit.
This test is mainly used for verification of continuity for cable/wires, or
identification of cable/wires. Ideally used for testing cable TV, electrical
cables, and telephone/speaker wiring in multi-room or multi-floor
installations. The remote continuity test mode can be used to check
continuity and identify two, three or more cables/wires by applying simple
logic and testing strategy.
1. Turn on the Main Unit and the Power LED light will turn green. If
LED light does not turn on, replace the battery.
2. Refer to Figure 2, attach the red and black clips of the Main Unit to
one end of cable/wires under test, then go to the other end of the
cable/wires and connect them to the test leads of the Remote Unit.
3. If continuity exists, the bi-color LED of the Remote Unit will flash
either green or red depending on the Remote Unit leads orientation.
Meanwhile the Main Unit will beep and the continuity LED will
flash red.
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
