6
l
a
u
n
a
M
s
’r
o
t
a
r
e
p
O
e
v
ir
D
r
e
w
o
P
D
P
1
0
3
5
9416-55301
Support
Bar
Feed Screw
Handle
Pipe
Cutter
Figure 3
OPERATION USING HAND TOOLS
WARNING: OPERATOR SHOULD BE THOROUGHLY
FAMILIAR WITH PRECEDING SAFETY PRECAUTIONS
BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT.
INSTALLING PIPE IN POWER DRIVE
1. Measure and mark length of pipe being worked.
2. If pipe is long enough to be retained by centering device,
insert pipe through front or rear of machine. If pipe is
short, insert into front of machine.
3. Make certain that pipe is centered in centering device, if
used, and tighten centering device.
4. Tighten CHUCK JAWS with a repetitive, counter-clock
wise snap spin of HANDWHEEL. This hammering ac-
tion tightens jaws on pipe. A clockwise rotation snap spin
releases jaws.
CUTTING PIPE WITH HAND CUTTER
1. Install pipe.
2. Engage pipe cutter with pipe and align cutter wheel with
mark on pipe.
3. Rest PIPE CUTTER frame on SUPPORT BAR
(Figure 4) located on switch side of machine. Tighten
FEED SCREW HANDLE.
4. With power cord plugged in, turn
REV
/
OFF
/
FOR
switch to
FOR (forward) position.
5. Place foot on FOOT SWITCH (Figure 2) to operate
machine.
6. Continuously tighten feed screw handle (Figure 3) with
both hands until pipe cutoff is completed.
7. Release foot switch and turn
REV
/
OFF
/
FOR
switch to
OFF position.
REAMING PIPE WITH HAND REAMER
NOTE: SPIRAL SELF FEEDING REAMERS ARE NOT SUIT-
ABLE FOR POWER DRIVE USE.
1. Turn
REV
/
OFF
/
FOR
switch to FOR (forward position).
2. Insert reamer into end of pipe and hold firmly onto handle
and handgrip (Figure 5).
3. Step on foot switch and push on reamer handgrip
(Figure 5) with right hand to ream pipe.
4. Release foot switch, remove reamer and turn
REV
/
OFF
/
FOR
switch to OFF position.
THREADING PIPE WITH HAND THREADER
1. Place threader on end of pipe with handle resting on sup-
port bar (Figure 4) located on switch side.
2. Place 06150 Oiler (Figure 6) under threader and apply
REED Thread Cutting Oil on pipe end.
3. Turn
REV
/
OFF
/
FOR
switch to FOR (forward) position.
4. Step on foot switch and push threader (Figure 4) with
right hand to engage dies.
NOTE: THREADER IS AUTOMATIC ONCE DIES ARE
ENGAGED. APPLY PLENTY OF OIL (FIGURE 6) UNTIL
THREADS ARE COMPLETED.
5. Release foot switch once threads are completed.
6. Push back support bar (Figure 4) on switch side.
7. Reverse THREADER RATCHET KNOB.
8. Lower threader handle and pull support bar out. Threader
handle is now against lower side of support bar.
9. Turn
REV
/
OFF
/
FOR
switch to REV (reverse) position
and back off threader by stepping on foot switch.
10. Release foot switch and turn
REV
/
OFF
/
FOR
switch to
OFF position.
Figure 2
Centering
Head
Chuck Jaw
Handwheel
Foot
Switch
REV/OFF/FOR
Switch
Pipe
