16
Note:
If a card is not inserted or the card is defective, the meter will flash
"CArD -E-". In this case, power the meter OFF and try again with another
SD memory card or verify that the card is correctly inserted.
8. To exit manual data logging mode, press and hold the
REC
button
2 seconds to resume normal operation.
Automatic Data Logging Mode
In automatic mode the desired data logging sampling rate is set to 1, 2, 5, 10,
30, 60, 120, 300, 600, 1800 or 3600 seconds prior to recording (see
Setting
the Data Logging Sampling Rate
section for details). In order to setup the
meter for automatic data logging, follow steps 1 through 5 below.
1. To begin a data logging session, press the
REC
button and "REC"
will appear on the LCD.
2. Press the
LOG
button. The meter will scan for a SD memory card.
Note:
If a card is not inserted or the card is defective, the meter will flash
"CArD -E-" indefinitely. In this case, power the meter OFF and try again
with another SD memory card or verify that the card is correctly inserted.
3. The "REC" icon will appear on the LCD and will continuously flash
while in a data logging session.
4. To pause the data logging session press the
LOG
button and "REC"
will stop flashing. To resume press the
LOG
button again.
5. To end the current data logging session pause the data logging
session and hold the
REC
button until "REC" disappears.
Transferring Data from the SD Memory Card to a Computer
1. While the meter is powered Off remove the SD memory card from the
SD card slot.
2. Insert the SD memory card into the computer.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
