12
2. Press the
AL
and
SET
buttons to scroll through the stored values.
3.
To clear the stored values, press and hold the MEM button first and then
press the
button.
Note:
If no values are stored or if the memory is cleared the display will
appear as shown below.
4. Press the MEM button to exit memory recall mode and resume
normal operation.
Setting the Critical Alarms
1. Press the
AL
button to turn the critical alarm mode ON or OFF.
2. Hold the
SET
button for approximately 3 seconds to enter the critical
alarm set up mode.
3. Press the
SET
button to toggle between digits.
4. Press the
AL
and
MEM
buttons to adjust the flashing digit.
Note:
The maximum set critical alarm value that can be set is 199Ω/499mA.
5. Press the
SET
button to confirm your selection and proceed to the
next digit.
6. When complete, hold the
SET
button for approximately 3 seconds to
exit the critical alarm set up mode and resume normal operation.
Note:
When the critical alarm is enabled, the instrument will begin to beep
if the measured vale exceeds the selected alarm.
7. Follow steps 2 to 6 to set the critical alarm in mA.
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
