SUSSEX
POL FLOOR MOUNT MIXER CURVED
INSTALLATION INSTRUCTIONS
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
Rough in Plumbing
- 3/8” Copper Tube is to be used to connect to the “Push-on” fittings of this
Floormount Mixer.
- The clearance hole size through the finished floor is to be between 28 - 32mm.
- The Hot and Cold Copper Tube lines should be installed with 18mm centres.
- Use the template provided to gain correct spacing between the Copper Tube and
for the direction of the spout .
- The Hot and Cold 3/8” Copper Tube must be trimmed to protrude through the
finished floor surface by 25-30mm.
- The Copper Tube must be vertical and central within the floor penetration.
- Brace/Secure the 3/8” Copper Tube lines to prevent movement when installing
the mixer.
- The Copper Tube ends must remain round and completely de-durred (free from
any sharp edges).
- Note: Where possible, it is recommended to fit isolating valves.
Installation of Mixer
- Place template over the protruding 3/8” Copper Tube to mark fixing hole
positions, remove and drill to suit appropriate fasteners. (Fasteners not included)
- Drilling Template must be removed prior to fit off.
- Unscrew Cover flange and gently slide away from the Floor Fitting.
- Note: Finished floor surface must be completely sealed and water tight around
copper tube ends prior to final fit-off.
- Apply grease to Copper Tube ends and gently attach the “Push On” Fittings. Full
engagement is approx. 20mm.
- Lower Mixer and align the Floor Fitting.
- Ensure “FRONT” of mixer body is facing the bath.
- Perform a water test before permanently fixing Mixer to floor.
- Secure to floor and check with level ensuring mixer is square.
- Where required, level mixer by adjusting the 4 jacking screws located in the Floor
Fitting.
- Gently lower the Cover Flange onto the Floor Fitting and hand tighten.
- Check Mixer operation.
Tapware is to be installed by a Licensed
Plumber in accordance with AS/NZL 3500
Water pressure is not to exceed 750 Kpa
Recommended working water pressure 300 - 500 Kpa.
Maximum water temperature is 55 deg.C.
TEMPL ATE
18mm Centres
Fixing Hole positions
(4 Places)
3/8" Copper Tube
Positions
Spout
Direction
Floor
Clearance
Hole size
28 - 32m m
H C
H C
3/8"
Copper Tube
25 - 30 mm
28 - 32mm Floor Clearance Hole
The Copper T ube ends must remain round and
Cover
Flange
Floor Fitting
(Do Not Remove)
"Push On"
Fittings
Finished Floor
Surface
FRON T
page 2 of 3
