ISSY //
Z8 BUTTERFLY TALLBOY
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
Note: It is recommended that you use an Installation stand
(Not included) to assist the installation of this Shaving
Cabinet. This unit being level is imperative to the
Overall installation.
1. Ensure you measure correctly so that the top of the shaving cabinet
aligns flush with the top of the Tall Storage Unit. DETAIL: A
2. You can drill through any part of the back of the unit into the wall.
Ensure you have at least 4 points of contact to studs. These screws
can be hidden with the timber plugs included.
3. If required, you can also fix the Shaving Cabinet to the Tall Storage
Unit internally (again neatly drill and countersink holes before
screwing together)
Installing the Shaving Cabinet
Note: It is recommended the gap between vanity and shaving cabinet is
measured at both ends to ensure level installation.
ENSURING SCREWS ARE FIXED TO STUDS Please fix Vanity Unit to studs at 4
point (minimum) for a 1000mm vanity, and 6 points for a 1500mm vanity.
1. The unit needs to be placed to line up with the plumbing system/ and
the units above and below. Standard mounting height is 760mm from
the ground to the top of the Corian.
2. You can drill through any part of the back of the unit into the wall.
Ensure you have at least 4 points of contact to studs.
Installing the Vanity
Re-attaching the Drawers
1. Fully extend the drawer runner and place drawers on the guides
2. When pushed closed these should click together and run smoothly. If
the drawers do not click together or don’t run freely, remove and repeat
the step.
INSTALLATION INSTRUCTIONS
DETAIL: A
page 6 of 8
