by
OPEN SKY DESIGN
ISSY
GLIDE VANITY UNIT
INsTALLATIoN INsTRUCTIoNs
Vanity should be installed by a qualified, licensed trades person.
Vanity Fitting Instructions
• Prior to installation it is important to inspect the vanity to ensure no damage has occurred in transit. If damage
has occurred, or a visible defect exists, do not proceed with installation and advise supplier immediately. No
warranty claim for damage will be accepted if the vanity is installed.
• It is recommended that the Solid Surface Top is protected during installation.
Please Note:
Manufacturer will not be liable for the cost of installation or removal of the vanity and the warranty
will be voided if damage occurred during or after installation.
• Remove drawers (refer to Drawer Installation and Adjustment Instructions)
• Mark base and back of the vanity for drilling to allow for plumbing pipes.
• Drill holes for pipes with appropriate size hole saws.
• Position vanity over pipes in correct position.
• It is recommended that the vanity sit on a length of aluminium angle securely fastened to the wall
• Check with spirit level that the vanity is completely level.
• Screw vanity to the wall through back of the vanity, ENSURING SCREWS ARE FIXED TO STUDS. Allow
enough fixing points at the top and bottom of the back panel to sufficiently secure the unit to the wall.
• All edges where vanity top and cabinet meet wall and floor are to be properly sealed with bathroom grade sili-
cone to prevent water penetration. Materials used in construction are water-resistant not waterproof. Care must
be taken to dry any spillage or leakage of water which may gain access to the cabinet when fitting.
• Replace drawers (refer to Drawer Installation and Adjustment Instructions).
Recommendation for Plumbing
Waste should not be over tightened to avoid stress on basin and top.
PLUmBING AND ELECTRICAL sEToUT INsTRUCTIoNs
1. Diagrams below show wall positions of 40mm waste pipe , hot and cold outlets (if required) and power cord
outlet (if required). Please note diagrams show set outs for 750 , 1200 and 1500 left hand basin , for right hand
basin use mirror opposite .
2. Use 40mm plug and waste , non overflow with 40mm Short Inlet P Trap (both not supplied)
3. For power cord positioning of custom sizes , contact manufacturer .
4. Plumbing set outs for customised sizes:
751 - 850 same as for 750 set out
1000 - 1300 same as for 1200 set out
1400 - 1499 same as for 1500 set out
5. For plumbing and electrical set outs of customised 1751 - 2000mm double basin contact manufacturer .
6. Sensor Powered Drawers
A 1.6 mtr power cord extension is fitted to the vanity and extends out the back of the unit at the position
shown in the diagram below. This power cord should be connected by a qualified electrician to a 240 volt
power supply with an isolating switch.
Please Note:
Any electrical fault caused by water penetration inside the vanity is not covered by the product
warranty
7. If using a basin mixer, hot and cold hoses should be bracketed to the side or back of the vanity so as not to
impede operation of the drawer.
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
page 4 of 6
