11
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
do this, the console displays or other electrical
components may become damaged.
Plug in the power cord
(see page 9). Next, locate
the reset/off circuit breaker
on the treadmill frame
near the power cord.
Switch the circuit breaker
to the reset position.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as
you plug in the power cord and switch the reset/off
circuit breaker to the reset position, the demo
mode is turned on. To turn off the demo mode,
hold down the Stop button for a few seconds. If the
displays remain lit, see THE INFORMATION MODE
on page 17 to turn off the demo mode.
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key (see the drawing on page 10)
and slide the clip onto the waistband of your clothes.
Then, insert the key into the console. After a moment,
the displays will light.
IMPORTANT: In an emergency
situation, the key can be pulled from the console,
causing the walking belt to slow to a stop. Test the
clip by carefully taking a few steps backward; if the
key is not pulled from the console, adjust the posi-
tion of the clip.
HOW TO USE THE MANUAL MODE
1. Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2. Enter your weight if desired.
If you enter your weight
into the console, the con-
sole will display a more
accurate estimate of the
number of calories that
you burn. To enter your
weight, press the Your Weight increase and de-
crease buttons repeatedly. Note: Once you have
entered your weight, it will be saved in memory.
3. Select the manual mode.
When the key
is inserted,
the manual
mode will be
selected. If
you have se-
lected a work-
out, reselect the manual mode by pressing either
of the workout buttons repeatedly until a track ap-
pears in the upper half of the display.
4. Start the walking belt.
To start the walking belt, press the Start button, the
Speed increase button, or one of the speed but-
tons numbered 1 to 10.
If you press the Start button or the Speed increase
button, the walking belt will begin to move at 1 mph.
As you exercise, change the speed of the walking
belt as desired by pressing the Speed increase
and decrease buttons. Each time you press a but-
ton, the speed setting will change by 0.1 mph; if
you hold down a button, the speed setting will
change in increments of 0.5 mph. Note: After you
press the buttons, it may take a moment for the walk-
ing belt to reach the selected speed setting.
If you press one of the numbered speed buttons,
the walking belt will gradually change speed until it
reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To restart
the walking belt, press the Start button, the Speed
increase button, or one of the numbered speed but-
tons.
5. Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons or one of
the incline buttons num-
bered 0 to 10. Each time
you press the Incline increase or decrease button,
the incline will change by 0.5%. If you press one of
the numbered incline buttons, the treadmill will ad-
just to the selected incline setting. Note: After you
press the buttons, it may take a moment for the
treadmill to reach the selected incline setting.
Reset
Position
Track
