1
Two adults are required to complete assembly. To
prevent serious injuries, the pole should be held down
by one adult at all times while filling the Base.
34
Filling the Base with Sand
With the Backboard extended to its highest position,
use a funnel and fill the Base with 375 lbs. of sand.
Filling the Base with Water
Check the Base Cap for leaks
frequently.
Carefully stand the system up.
Carefully stand the system up.
Never put the system in an upright position without proper
weight in the Base. The system may fall over and could
result in serious personal injury or property damage.
WARNING
For safety reasons, we recommend
that sand be used instead of water
to fill the Base.
If a leak develops, water could run
out unnoticed, allowing the unit to
fall over and resulting in serious
personal injuries or property
damage. Check the Base carefully
for leaks.
AH
AH
Screw the Base Cap (AH) onto the Base.
Screw the Base Cap (AH) onto the Base.
With the Backboard extended to its highest position, fill the Base
with cold water and one tablespoon of chlorine bleach.
AW
AW
Warning sticker (AV)
Lay the Pole Pad (AW) flat on the ground. Apply
the extra Warning Sticker (AV) onto the Pole
Pad just below the logo at the top of the Pole
Pad. Eliminate any air bubbles in the Sticker.
Attach the Pole Pad (AW) to the pole. The bottom strap
should go below the Pole Braces.
35
Apply the two Logo Stickers to the Backboard
in the locations shown.
36
