RedSeven Amplification duality D50, Руководство пользователя

Страница: 11 / 14

11
LOOP FX
Loop effects on D50 is between preamp output and power amp input, right before
master volume. It’s a buffered 100% serial loop fx with instrument level signal.
When loop effect is engaged 100% of your sound will pass thru the effect wired to
send/return jacks. When it’s bypassed, the signal goes straight from preamp to power
amp.
There’s no specific send/return control on back panel but channel volume acts as a
“send control” (the amount of signal to be sent to the input of your effect) and master
volume acts as “return control” (the amount of signal returning from your signal back
into
the power amp).
Loop effect can always be activated/bypassed thru the front tactile switch, the
footswitch or via midi PC/CC.
SUGGESTION: if you are hearing some bad clipping sound when loop effect is on,
you’re probably overloading the input of your effect. Try to lower the preamp signal
(by lowering channels volume on the D50 or the input control or your effect) then
increase the incoming signal to return jack (by increasing master volume on D50 or
output volume of your effect)
D50F FOOTSWITCH
Duality comes with D50F footswitch. It can operate only with D50 model, so it can’t be
used with D100 model.
D50F also can’t be used with other amplifiers or devices, since it can be damaged by
incorrect uses.
D50F can basically do same things as the player can do with keypad situated on the
right side of the front panel. It can:
-
skip between CLEAN and DIRT channels;
-
skip between VINTAGE and MODERN modes on dirt channel;
-
turn on/off LEAD boost on both VINTAGE and MODERN modes;
-
turn on/off MASTER 2;
-
turn on/off LOOP FX;