Redring 47789501, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 12

4
Instructions for use and maintenance
The element heats the water in the tank and is controlled
by the thermostat, automatically maintaining the preset
temperature. The plastic control panel incorporates: switch
(depending on model), adjustable thermostat (depending
on model), and thermal cut-out and control lamps.
The thermal cut-out switches off the power supply should
the water temperature reach excessive values. If this device
is actuated, you should call a the service helpline above.
The signal lights on the control panel indicate the current
mode of the unit.
The magnesium anode provides additional anticorrosion
protection to the internal tank.
3. The safety valve prevents the appliance from
emptying in the event of cold water supply
interruption. The valve protects the appliance from
pressure increases higher than the allowed value
during heating (note: pressure will increase when
temperature increases), by releasing the excess
pressure through the drain outlet. Excess water exiting
into the drain during the heating process is a normal
event that must be taken into consideration when the
boiler is installed.
ATTENTION! The safety valve cannot protect the
appliance in the event of water mains pressure exceeding
the rated pressure stated for the appliance (6 Bar).
V. INSTALLATION AND SWITCH ON
1. Installation
We recommend installation of the device close to the
likely outlet (i.e. Tap) where hot water is used, in order to
reduce heat losses. The selected installation location must
be clean and dry at all times.
The appliance is affixed to a wall by means of mounting
brackets attached to the unit‘s body.
Two hooks are used to fix the appliance (min. Ø 6 mm)
firmly on the wall (included in the mounting set). The
bearing plank construction for boilers installed
under
sinks is universal and allows the space between hooks
to vary between 96 and 114mm. (fig.2)
IMPORTANT: The TS Line Boilers are designed for
installation
under sinks with the outlet/inlet pipes
pointed upwards (to the ceiling). Under no circumstances
should these units be fitted upside down, with the outlet/
inlet pipes pointing towards the floor.
For clear understanding of wall installation schemes,
please refer to fig.2.
ATTENTION! Don‘t place objects, which are not
waterproof under the appliance under any circumstances.
2. Water heater connection to the water supply system
Cold Water Pack Instructions
When water is heated
it expands. In a small
unvented water heater of
this type the expansion
can normally be
accommodated back into
the cold water mains, as
indicated in the Water
Regulations.
Where this is not possible
the installer will need to fit
a set of cold water controls
fig. 4a