Redpine Signals, Inc. Proprietary and Confidential
Page 7
User Manual
Version 1.2.1
6) External PA Enable/Disable
7) Rate Flags like Short GI, Greenfield, etc.
8) Enable/Disable Aggregation
9) Number of packets to be transmitted in Burst Mode
10)Delay between packets in Burst Mode
11)Regulatory Domain
2.1.1 Transmit Command
./transmit
<tpow><rate><len><mode><chan><expa><rf><aggr><num><delay
><reg>
2.1.2 Transmit Command Description
The command usage is explained below.
<tpow>: Transmit power in dBm for controlling transmit power. To set
the transmit power value, enter a value either between -7 and18.If a
value of 127 is entered, the packet will be transmitted at the maximum
power from the Transmit power table in the module.
<rate>: Transmit Data Rate. To set the transmit data rate, select a value
from 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, 54, mcs0, mcs1, mcs2, mcs3,
mcs4, mcs5, mcs6 and mcs7.
<len>: Transmit packet length in bytes. Enter a value between 24 and
1536 when aggregation is not enabled and between 24 and 30000 when
aggregation is enabled.
<mode>: Transmit mode. Enter 0 for Burst mode and 1 for Continuous
mode.
<chan>: Transmit channel number
. The following table maps the
channel numbers to the center frequencies for 20MHz and 40MHz
bandwidth modes in 2.4GHz and 5GHz band.
Band
(GHz)
Bandwidth
(MHz)
Channel
Number
Center Frequency (MHz)
2.4
20
1
2412
2.4
20
2
2417
2.4
20
3
2422
2.4
20
4
2427
2.4
20
5
2432
1
This is not supported in the current release.
2
On-air testing in DFS channels should be avoided till the module is certified for DFS. Cabled tests can be
run in these channels.
