RedMax STICK HEZ2450S, Руководство владельца/оператора

Страница: 14 / 19

Maintenance, replacement, or repair of the emission control device and systems may be performed by any
non-road engine repair establishment or individual.
• Always be sure to stop the engine before inspecting the stick edger for problems or performing
maintenance.
• Never alter the stick edger or take the engine apart.
• When replacing parts, always be sure to use only RedMax products or products which have been
certified by RedMax for use with the RedMax stick edger.
WARNING
■
BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER
US-14
HEZ2450S/HEZ3050S
9. Maintenance
every every every
25 50 100
system/compornent procedure before hours hours hours note
use after after after
fuel leaks, fuel spillage wipe out
✔
fuel tank, air filter, fuel filter inspect/clean
✔ ✔
replace, if necessary
see
■
ADJUSTING replace carburetor
idle adjusting screw
✔
IDLING SPEED (p.13) if necessary
clean and readjust GAP: .025in(0.6~0.7mm)
spark plug
✔
plug gap replace, if necessary
cylinder fins, intake air cooling vent clean
✔
muffler, spark arrester, cylinder exhaust port clean
✔
throttle lever, ignition switch check operation
✔
replace if
cutting parts
✔
something's wrong
drive shaft grease
✔
gear case grease
✔
screws/nuts/bolts tighten/replace
✔ ✔
not adjusting screws
cutting blade inspect/replace
✔
replace, if necessary
ENGINE
SHAFT
■
MAINTENANCE CHART
Item to be checked Response
1 Edging mechanism • See if attachment is loose • Tighten screws and bolts
• Check if edges of blades are dull • Sharpen or replace blades
2 Throttle • Stiff and difficult to move • Repair or replace
3 Throttle wire • Too loose, too tight • Adjust
• Stiff and difficult to move • Repair or replace
4 Engine attachment • See if fittings are loose • Tighten fittings
5 Fuel tank • See if attachment is loose • Tighten screws and bolts
• See if fuel pipe is damaged • Replace
• See if cap packing is damaged • Replace
6 Muffler • See if attachment is loose • Tighten screws and bolts
7 Cutting blade • See if damaged or worn shorter than usable • Replace
length