RedMax SGC2300DL, Руководство владельца/оператора

Страница: 12 / 22

How to use
WARNING!!!
1 . Always wear eye protection such as safety
goggles. Never lean over the rotating cutting
head. Rocks or other debris could be thrown
into eyes and face and cause serious per­
sonal injury.
2. Keep the debris fuard attached in place at
alltimes when the unit is operated.
• Adjust the front handle to the most comfort­
able position.
• Start the engine and pull the throttle lever
Before cleaning, inspecting or re­
pairing your unit, make sure that
engine has stopped and is cool.
A. After every use
• Remove all dust, dirt and grass from the
entire unit.
• Check complete unit for loose or missing
fasteners or parts. Correct if found.
• Check engine for any fuel leaks.
gradually. The blades will start moving as the
B. Blade Maintenance
engine speed goes up.
• To stop the blade motion, simply release the
throttle lever. The clutch will disengage and
the blades stop moving while the engine
keeps idling.
• Move the cutting head as sliding its bottom
on the ground. This will help you do the job
with less effort.
Note:
• Avoid running the engine at full throttle
with no load. Continuous no load full
throttle operation can cause damage to
the engine and driveshaft.
• Operation at too slow engine speed can
cause abnormal vibration of the ma­
chine, resulting in short life of driveshaft
and clutch parts. If you felt such vibra­
tion, use a higher speed range.
• Though the blades are made of harder
steel compared to conventional metal
blades, continuous cutting in soil will
accelerate wear.
( 10 J
ill
Use protective gloves whenever
inspecting, removing, sharpening,
and installing the blade.
• Wipe off dust and dirt attached to the blade,
and oil it after every use.
• As the extent of wear differs by each cutter
depending on use conditions, rotate the
blade position at intervals.
To Remove Blades:
1. Turn over the machine and remove the
bottom cover by removing the four cross­
slotted screws.
2. Loosen the four socket screws and re­
move the lower blade.
3. Loosen the four socket screws and re­
move the upper blade.